0

Out of 0 Ratings

Owner's of the Onkyo Stereo Receiver Stereo Receiver gave it a score of 0 out of 5. Here's how the scores stacked up:
  • Reliability

    0 out of 5
  • Durability

    0 out of 5
  • Maintenance

    0 out of 5
  • Performance

    0 out of 5
  • Ease of Use

    0 out of 5
of 36
 
En-22
Enjoying Audio Sources—Continued
Press the [DIRECT] button. The message
“DIRECT MODE” appears.
When the DIRECT function is on, the
tone controls are bypassed, so you can
enjoy pure sound.
To cancel the DIRECT function, press the [TONE]
button again, and the message “TONE MODE” appears.
The tone controls can be used to adjust the sound.
You can configure whether the DIRECT function is
applied or not for input sources individually.
If you connect a component to a digital audio input, you
must assign that input to an input selector. For example,
if you connect your RI Dock to the OPTICAL, you must
assign “OPT” to the “DOCK” input selector.
Here are the default assignments.
COAX1, COAX2, OPT:
Select the corresponding digital audio input, to which
the component has been connected.
–––––:
Select if the component is connected to an analog audio
input.
Note:
The maximum sampling rate for PCM signals from a
digital input (optical and coaxial) is 96 kHz/24 bit.
1
Press the [] button to turn on the power.
2
Press the [SETUP] button on the remote
controller.
3
Use the arrow []/[] buttons to select
“Digital Input,” and then press [ENTER].
4
Press the arrow [
]/[
] buttons to select the
input that you want to change the assignment.
For example, select “DOCK” to assign to “OPT”.
5
Press the arrow []/[] buttons to select an
input terminal.
For example, select “OPT”.
6
Press the [ENTER] button to confirm the
setting.
7
Press the [SETUP] button on the remote
controller to complete the setting.
Notes:
This procedure can also be performed on the receiver
by using [SETUP], TUNING []/[], PRESET []/
[], and [ENTER].
Press [RETURN] to return to the previous menu.
This procedure will be cancelled if the [SETUP]
button is pressed before step 6.
DIRECT
M
SETUP
&(#5
ENTER
TONE
DIRECT TONE
MON/STANDBY
Setting the DIRECT Function
Setting the Digital Audio Input
(for European model)
Input selector Default assignment
BD/DVD COAX2
TV OPT
TAPE –––––
DOCK –––––
CD COAX1