4.0
Owner's of the Onkyo Stereo Receiver Onkyo Stereo Receiver gave it a score of 4.0 out of 5. Here's how the scores stacked up:
Advanced Operations
En-70
■ Operating on the AV receiver
■ Operating on the remote controller
To control Zone 2, you must press ZONE2 on the
remote controller first.
Adjusting the Volume for Zone 2
■ Operating on the remote controller
■ Operating on the AV receiver
If your Zone 2 speakers are connected to a receiver
or integrated amplifier in Zone 2, use its volume
control to adjust the volume.
Muting Zone 2
■ Operating on the remote controller
Tip
• To unmute, press ZONE2 followed by MUTING again.
Zone can also be unmuted by adjusting the volume.
Note
• Only analog, NET or USB input source is output from the
ZONE 2 LINE OUT jacks and ZONE 2 L/R terminals.
• You cannot select different AM or FM radio stations for your
main room and Zone 2. The same AM/FM radio station will
be heard in each room. Namely, if you have selected an FM
station for the main room, that station will also be output in
Zone 2.
• You cannot select different input selector NET or USB for
your main room and Zone 2. Namely, if you have selected
USB input selector for Zone 2, USB input selector will be
selected in main room even if NET has been selected for
main room.
• BLUETOOTH cannot be selected as input selector in
Zone 2. If you play audio from Bluetooth-enabled device in
Zone 2, select “Z2 Sel: Source”, and BLUETOOTH as
input selector in Main room.
• When Zone 2 is activated and its input selector is selected,
the power consumption of standby mode slightly increases.
• While Zone 2 is on, functions will not work.
• When setting the AV receiver to standby mode while
Zone 2 is active, the Z2 indicator is dimly lit.
• Activating Zones in the main room when the listening mode
is set to Pure Audio (European, Australian and Asian
models) will automatically switch it to Direct.
Controlling Zone 2 Components
1
To turn on Zone 2 and select an input source,
press ZONE 2 followed by an input selector
button within 8 seconds.
Zone 2 turns on, the Z2 indicator lights on the AV
receiver’s display.
To select the same source as the main room’s,
press ZONE 2 twice. “Z2 Sel: Source” appears
on the AV receiver’s display.
2
To turn off Zone 2, press OFF.
The zone is turned off.
ZONE 2 OFF MASTER VOLUME
Input selector buttons
RECEIVER
ZONE2
INPUT
SELECTOR
VOL /
MUTING
1
Press ZONE2, then point the remote controller
at the AV receiver and press RECEIVER.
Zone 2 turns on, the Z2 indicator lights on the AV
receiver’s display.
2
To select an input source for Zone 2, press
ZONE2, followed by an INPUT SELECTOR
button.
3
To turn off Zone 2, press ZONE2, followed by
RECEIVER.
The zone is turned off.
1
Press ZONE2.
2
Use VOL / .
1
Press ZONE 2 (the Z2 indicator on the AV
receiver’s display flashes).
2
Use MASTER VOLUME control within 8
seconds.
1
Press ZONE2 followed by MUTING.
Find Your Products By Category
Please Login
