4.0
Owner's of the Onkyo Stereo Receiver HT-RC430 gave it a score of 4.0 out of 5. Here's how the scores stacked up:
Controlling Other Components
En-48
Controlling Other Onkyo
Components
You can use the AV receiver’s remote controller to control
your other Onkyo AV components. This section explains
how to enter the remote control code for a component that
you want to control: DVD, CD, etc.
The following REMOTE MODE butttons are
preprogrammed with remote control codes for controlling
the components listed. You do not need to enter a remote
control code to control these components.
For details on controlling these components, see the
indicated pages.
You’ll need to enter a code for each component that you
want to control.
Onkyo components that are connected via are
controlled by pointing the remote controller at the AV
receiver, not the component. This allows you to control
components that are out of view, in a rack, for example.
Preprogrammed Remote Control
Codes
BD/DVD Onkyo Blu-ray Disc player (➔ page 50)
TV/CD Onkyo CD player (➔ page 51)
Entering Remote Control Codes
1
Look up the appropriate remote control code in the
Remote Control Codes for Onkyo Components
Connected via .
2
While holding down the REMOTE MODE button to
which you want to assign a code, press and hold
down DISPLAY (about 3 seconds).
The remote indicator lights.
Note
• Remote control codes cannot be entered for RECEIVER.
• Except for RECEIVER remote control codes from any
category can be assigned to the REMOTE MODE button.
However, these buttons also work as input selector buttons
(➔ page 20), so choose a REMOTE MODE button that
corresponds with the input to which you connect your
component. For example, if you connect your CD player to
the CD input, choose TV/CD when entering its remote
control code.
3
Within 30 seconds, use the number buttons to enter
the 5-digit remote control code.
The remote indicator flashes twice.
If the remote control code is not entered successfully,
the remote indicator will flash once slowly.
Remote Control Codes for Onkyo
Components Connected via
1
Make sure the Onkyo component is connected with
an cable and an analog audio cable (RCA).
See “Connecting Onkyo Components” for details
(➔ page 17).
2
Enter the appropriate remote control code for a
REMOTE MODE button, by referring to the
previous section.
`42157:
Onkyo cassette tape deck with
`81993:
Onkyo Dock with
3
Press the REMOTE MODE button, point the
remote controller at the AV receiver, and operate
the component.
To be continued
Find Your Products By Category
Please Login
