0
Owner's of the Onkyo Stereo Amplifier Onkyo Stereo Amplifier gave it a score of 0 out of 5. Here's how the scores stacked up:
42
En
There’s no sound.
• Make sure that the Onkyo Dock is connected to the
integrated amplifier properly.
• Make sure that no video content is being played.
• Reset the iPod.
Other
• When the Auto Standby (ASb) function is activated, the
power of the Onkyo Dock connected via is
automatically turned off (➔ page 38).
Can’t control properly by using the remote
controller.
• Make sure that the cable is connected to the
integrated amplifier correctly.
You need to change the input name to use function
(➔ page 35).
No sound is heard from a connected
component.
• Make sure the correct input source is selected
(➔ page 28).
• If “ROUTE” is set to anything other than “NORMAL”,
make sure that each component is connected accordingly
(➔ page 23 to 25, 39).
• Make sure the analog audio cable is connected correctly
(➔ page 16).
The sound from turntable is distorted.
• If your turntable (MM/MC) has a built-in phono preamp,
connect to other analog inputs such as LINE IN.
• If your turntable (MM/MC) does not have a built-in
phono preamp, connect a turntable to PHONO
(➔ page 21).
• Make sure that the ground wire is connected. Otherwise,
it may produce an audible hum and noise.
• Make sure the MM/MC selector is set in accordance
with the cartridge format of your turntable.
A popping noise is produced when the
power is set to on or off.
• Turn each of the components’ power on or off in the
following order.
When turning the power on:
1. Source component
2. Integrated amplifier (A-9070)
When turning the power off:
1. Integrated amplifier (A-9070)
2. Source component
The remote controller doesn’t work
properly.
• Make sure the batteries have been installed with the
correct polarity (+/–) (➔ page 7).
• Replace both batteries with new ones. (Do not mix
different types of batteries or new and old batteries.)
• The remote controller is too far away from the integrated
amplifier, or there’s an obstacle between them
(➔ page 7).
• The integrated amplifier’s remote control sensor is being
subjected to bright light (inverter-type fluorescent light
or sunlight).
• The integrated amplifier is located behind the glass
doors of an audio rack or cabinet.
Onkyo Dock
External Components
Remote Controller
Onkyo is not responsible for damages (such as CD
rental fees) due to unsuccessful recordings caused by
the unit’s malfunction. Before you record important
data, make sure that the material will be recorded
correctly.
The integrated amplifier contains a microcomputer
for signal processing and control functions. In very
rare situations, severe interference, noise from an
external source, or static electricity may cause it to
lockup. In the unlikely event that this should happen,
unplug the power cord, wait at least 5 seconds, and
then plug it again.
Before disconnecting the power cord from the wall
outlet, set the integrated amplifier to Standby.
If during idling the cover is too hot to touch, then
ventilation needs to be improved.
Find Your Products By Category
Please Login
