Frigidaire Refrigerator Frigidaire Refrigerator User Manual

0

Out of 0 Ratings

Owner's of the Frigidaire Refrigerator Frigidaire Refrigerator gave it a score of 0 out of 5. Here's how the scores stacked up:

  • Reliability

    0 out of 5

  • Durability

    0 out of 5

  • Maintenance

    0 out of 5

  • Performance

    0 out of 5

  • Ease of Use

    0 out of 5
of 33
 
17
IMPORTANT
Your ice maker is turned on at the factory so it can work
as soon as you install your refrigerator. If you cannot
connect a water supply, set the ice maker’s On/Off icon
to Off and turn off the water supply valve; otherwise,
theicemaker’sllvalvemaymakealoudchattering
noise when it attempts to operate without water.
IMPORTANT
On occasion, unusually small ice cubes may be noticed
in the bucket or in dispensed ice. This could occur in
normal operation of the ice maker. If you start seeing
these more frequently, it may be an indication of low
waterpressureorthewaterlterneedstobereplaced.
Asthewaterlternearstheendofitsusefullifeand
becomes clogged with particles, less water is delivered
to the ice maker during each cycle. Remember, if it’s
been six months or longer since you last changed your
waterlter,replacethewaterlterwithanewone.Poor
qualityhouseholdwatermayrequiretheltertobe
changed more frequently.
IMPORTANT
Turning off the ice maker will disable the ice dispenser.
You will still be able to dispense water.
AUTOMATIC ICE & WATER DISPENSER
NOTE
The water dispenser has a built-in device that shuts off the
waterowafterthreeminutesofcontinuoususe.Toreset
this shutoff device, simply release the dispenser paddle.
NOTE
The ice maker also has a built-in plastic signal bale arm
that automatically stops ice production when the ice bin
is full. This signal arm should not be used to manually
stop the ice maker.
CAUTION
For proper dispenser operation, recommended water
supply pressure should fall between 30 psi and 100 psi.
Excessivepressuremaycausewaterlter
to malfunction.
Priming the water supply system
1 Beginllingthetankbypressingandholdinga
drinking glass against the water dispenser paddle.
2 Keep the glass in
this position until
water comes out
of the dispenser.
It may take
about
1½ minutes.
3 Continue
dispensing water
for about four
minutestoush
the system and
plumbing connections of any impurities (stopping to
empty the glass as necessary).
Ice maker operation & care
After the refrigerator is installed properly and has cooled
for several hours, the ice maker can produce ice within
24hours.Theicemakerwilllltheicebinfromtherear.
You must dispense some ice to force the ice forward in
thebin.Thiswillallowthebintollcompletely.
Turning the fresh food ice maker on and off
Ice production is controlled by the ice maker’s On/Off
icon on the control panel. Press and hold the “Ice Off”
icon for three seconds to turn the ice maker “ON” or
“OFF”. The ice maker is turned off when the LED above
the “Ice Off” icon is illuminated.
Using the ice maker after installation
Beforemakingiceforthersttime,besuretoprimethe
water supply system. Air in new plumbing lines can result
in two or three empty ice maker cycles. Furthermore,
ifthesystemisnotushed,thersticecubesmaybe
discoloredorhaveanoddavor.
NOTE
Dispensed water is chilled. For colder water, add ice to
cup or container before dispensing water.

   Find Your Products By Category