0

Out of 0 Ratings

Owner's of the Electrolux Washer Electrolux Washer gave it a score of 0 out of 5. Here's how the scores stacked up:
  • Reliability

    0 out of 5
  • Durability

    0 out of 5
  • Maintenance

    0 out of 5
  • Performance

    0 out of 5
  • Ease of Use

    0 out of 5
of 44
 
30
Operating User Interface Features
Setting Preferences, continued
INSTALL CYCLE
Run the INSTALL CYCLE before operating the wash-
er the fi rst time. Remove all items from the washer
drum and press start. For more information on
performing the washer INSTALL CYCLE, refer to the
Installation Instructions accompanying this washer.
If the washer has been installed according to
Installation Instructions, INSTALL PASSED - DOOR
CAN BE OPENED
will be displayed and the washer
is ready to use.
If the washer was not installed properly, NO WATER -
OPEN WATER VALVES
, WATER HOSES - CHECK
WATER HOSES
or CALL SERVICE 877 435 3287
will be displayed to indicate the installation error.
The errors may result from the following conditions:
NO WATER —Water inlet hoses have not been at-
tached to water supply or water supply valves have
not been turned on. Install hoses correctly and turn
on water supply valves.
CHECK HOSES —The hot inlet hose may have
been connected to the cold water supply and the
cold inlet hose may have been connected to the
hot water supply. Check hoses for correct sup-
ply connection. If incorrect, disconnect hoses and
connect to correct inlets according to Installation
Instructions.
CALL SERVICE 877 435 3287 —Error can only
be corrected by calling a qualifi ed technician (1-
877-435-3287).
Repeat the INSTALL CYCLE when corrections are
completed.
RESET
Press the buttons indicated to restore only cycle set-
tings, reset only factory preferences (users, language,
brightness, volume, etc.) or restore all factory defaults
(both cycle settings and factory preferences). Press
the button under EXIT to return to normal operation
or press the cancel button to turn the washer off
without making any changes. If you do not make a
selection within 30 seconds the washer will return to
normal operation without any changes. If you reset
all settings, INSTALL CYCLE will be displayed as
though the washer were just turned on for the fi rst
time. You may press the button under CANCEL if you
do not wish to rerun the INSTALL CYCLE.
NOTE
The INSTALL CYCLE is prompted automatically
only once when the washer is turned on the
fi rst time at the end of installation. After that,
if you wish to run a subsequent INSTALL
CYCLE when moving the washer or modifying
your installation, you may perform your own
INSTALL CYCLE by selecting it in the set prefs
feature and then following the screen prompts.